2018-BUILDING CONDITIONS
2018- MANUFACTURED PRODUCTS
Install manufactured products and materials in accordance with the listing and/or the manufacturer’s installation instructions.
2018- STRUCTURAL OBSERVATION
1704.6 Structural Observations
Where required by the provisions of Section 1704.6.1, 1704.6.2 or 1704.6.3, the owner or the owner's authorized agent shall employ a registered design professional to perform structural observations. Structural observation does not include or waive the responsibility for the inspections in Section 110 or the special inspections in Section 1705 or other sections of this code.
Prior to the commencement of observations, the structural observer shall submit to the building official a written statement identifying the frequency and extent of structural observations.
At the conclusion of the work included in the permit, the structural observer shall submit to the building official a written statement that the site visits have been made and identify any reported deficiencies that, to the best of the structural observer's knowledge, have not been resolved.
2018- WELDS
All welds to be welded by W.A.B.O. certified welders or certified WABO shop.
2018-AMENDED DOCUMENTS
107.4 Amended Construction Documents
Work shall be installed in accordance with the approved construction documents, and any changes made during construction that are not in compliance with the approved construction documents shall be resubmitted for approval as an amended set of construction documents.
2018-CODES
This permit application shall conform to the 2018 edition of the International I-Codes (IBC, IRC, IMC.) and 2018 WSEC.
2018-SPECIAL INSPECTIONS
1703.6 SPECIAL INSPECTIONS Evaluation and Follow-Up Inspection Services
Where structural components or other items regulated by this code are not visible for inspection after completion of a prefabricated assembly, the owner or the owner's authorized agent shall submit a report of each prefabricated assembly. The report shall indicate the complete details of the assembly, including a description of the assembly and its components, the basis upon which the assembly is being evaluated, test results and similar information and other data as necessary for the building official to determine conformance to this code. Such a report shall be approved by the building official.
2018-STRENGTH
1604.2 Strength
Buildings and other structures, and parts thereof, shall be designed and constructed to support safely the factored loads in load combinations defined in this code without exceeding the appropriate strength limit states for the materials of construction. Alternatively, buildings and other structures, and parts thereof, shall be designed and constructed to support safely the nominal loads in load combinations defined in this code without exceeding the appropriate specified allowable stresses for the materials of construction.
Applied | Notice | 12/02/2021